JXK-606B

Car parking sensor system

4 sensor probes BIBIBI...buzzer alarm speaker parking sensor system

Details of JXK 606B

4 sensor probes (diameter:22 mm / the lenth of the line:250mm)

1 mian part box built-in dual cpu for accurate working

1 bibibi buzzer for alarm voice sound

1 power line

1 3M for buzzer fix

1 3M for main part box fix 

1 drilling bit for sensor probes installation 

drivers always collide when they are parking,especially new drivers.because they can not see bodies near behind their car.at this time ,they need parking sensor system:bibibi buzzer alarm parking sensor system JXK-606B

first you need to choose 4 position for the sensor probes(about 55-70cm height from ground)

drill 4 holes on your car bumper with the drilling bit

take the 4 sensor probes into these 4 holes and connect their lines with the ports on the main part box inside your car

then take the plug of the bibibi buzzer into the port on the main part box

the same,choose a best position for the buzzer to fix it in your car with the 3M

at last,take the power line plug into the main part box ,and connect the red line with the positive pole of  back-up lamp of your car,and make the black line ground connection,

so it's all for installation of all parts

when you take reverse gear,the buzzer parking sensor system would be woke.these 4 sensor probes will sense all bodies back of your car.and will sound alarm voice when the bodies are between 0.3-1.5m far from your car back.you can control car's brake at the right time.

all is keep you safe.

all parts of 4 sensor probes bibibi buzzer alarm parking sensor system JXK 606B

circuit board of main part of 4 sensor probes bibibi buzzer alarm parking sensor system JXK 606B

main part box of 4 sensor probes bibibi buzzer alarm parking sensor system JXK 606B

drilling bit of 4 sensor probes bibibi buzzer alarm parking sensor system JXK 606B

sensor probes of 4 sensor probes bibibi buzzer alarm parking sensor system JXK 606B